3D Print files for the Federated Arms ‘Vindicator’, as seen in the 2017 gameplay trailer of Cyberpunk 2077 by CD Project Red.

Features:

• Moving trigger (requires a pen spring and M3 20mm pin)

• Moving slide

• Removable Magazine

• 9mm dummy bullets (which fit the top of the magazine!)

• 0.2mm tolerance between sliding parts (this should give you a snug fit, I’ve included test files so you can check your printer without having to print the whole part)

I modeled this in fusion 360 using references taken from screenshots. Despite the imperfect nature of the screenshots (lens distortion, bad lighting, angles, etc), I’ve tried to replicate every detail as closely as possible.

For more about my process check out the project write-up.

I’ve included a couple of splits for the larger pieces, but you’ll most likely need to split them up further depending on how you like to print things.

I hope you like it!

For non-commercial use only. If you do use it in some way, I’d love to see it!

This is a FREE resource. credit card info is NOT required. However a billing address IS needed for the form to work. (though feel free to just put a fake one in!)

A DOWNLOAD LINK WILL BE SENT TO YOUR EMAIL ADDRESS